cecotec CONGA ROCKSTAR 1500 ULTIMATE ERGOFLEX Manual De Instrucciones página 43

Fig. 16
Assembling attachments
Fig. 17
Fig. 17.1
5. CLEANING AND MAINTENANCE
5.1 FILTERS AND TANK CLEANING
- Disconnect the appliance from the power supply, take the battery out, and allow it to cool
down before cleaning.
- To avoid the appliance from overheating and losing suction power, it is suggested to clean
the filters frequently. To make the most of the suction power, it is suggested to clean the
filter every week.
- The filter's lifespan will vary depending on the time of operation and the type of particles
vacuumed normally, and it is suggested to replace them every 6 months.
- To take the filters out, press the dust tank opening button, marked with the word "CLEAN",
and pull on the metallic handle to remove the filtering system. Once the filtering system is
out, turn the metallic handle anticlockwise and take the high-efficiency filters out.
Fig. 18
- To properly clean both filters, they can be either cleaner while dry, or cleaned while dry and
then with water (no cleaning product).
Fig. 19
Important
- To avoid motor defaults after cleaning the filter with water, the filters must be reinstalled
when completely dry.
- To empty the dust tank, press the dust tank's lower opening button, open it, and empty it.
Fig. 20
Cleaning the appliance
- Use a soft, damp cloth to clean the device's surface.
- Do not immerse the appliance in water or other liquid.
- Do not use abrasive cleaners or scouring pads to clean the product.
- After the brush has been used for a long time, bristles might start to tangle with hair and
other particles. Clean it in order for it to operate correctly again.
Cleaning the Jalisco brush and the Best Friend Care brush
- Move the rotary brush release button with the finger toward the arrow and remove the
CONGA ROCKSTAR 1500 ULTIMATE-ERGOFLEX
ENGLISH
43