cecotec CONGA ROCKSTAR 1500 ULTIMATE ERGOFLEX Manual De Instrucciones página 44

ENGLISH
cover of one of the ends of the brush.
- Take one end of the brush out as shown on the image.
- It is important to clear and clean all the residues left in the brush's rotary axis.
- After washing and drying all the parts, assemble it back in order to use the brush again.
Fig. 21
How to remove the battery
Press the battery release button and take the battery out as shown on the image. Store the
battery in a plastic bag and leave it in a dry place.
Fig. 22
Storing the device
- If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place.
- Maintenance indicator
- The full tank icon or the obstructed filter icon will be displayed if the device has not been
properly and frequently maintained.
Fig. 23
6. TROUBLESHOOTING
Problem
The motor does not operate.
The suction power has been
reduced and the appliance
makes a lot of noise.
Fig. 23
Insufficient operating time
after charge.
(The battery life may vary
according to the room
temperature).
CONGA ROCKSTAR 1500 ULTIMATE-ERGOFLEX
44
Possible cause
The battery does not work
any longer.
The metallic tubes, floor
brushes, batteries, or the
device itself are not properly
assembled.
The dust tank is full.
The filter has too much dust.
The electric rotary brush inlet
is obstructed, or the brush is
blocked.
Insufficient charge time.
The battery is old.
Solution
Charge the vacuum cleaner.
Make sure all parts of
the device are correctly
assembled.
Clean the dirt.
Clean or replace the filter.
Clean the dust inside the
electric rotary brush.
Fully charge the battery
following the instructions in
this manual.
Batteries are easily
recycled. Go to the closest
maintenance point and buy
new batteries.