Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Make sure your grill is assembled correctly. Each grill comes with detailed
assembly instructions that include assembly procedures specifi c to each model.
Follow these instructions carefully to ensure the correct and safe assembly of the
grill.
CAUTION
Risk of injury! Despite all eff orts to make assembly as easy as
possible, when handling the steel parts it is possible that corners
and edges can cause cut injuries if handled improperly during
assembly. Be careful when handling parts during assembly. It is
strongly recommended to wear work gloves during assembly.
INSTALLATION
Preparation
•
To operate this gas grill you need a gas bottle (liquid gas) and a suitable gas
pressure regulator. The controllers should comply with the EN 12864 standard
(as amended) and national regulations.
•
Connect the hose and regulator to the gas container on the left-hand side of
the gas grill, taking care to keep the gas container away from heat and in a
safe position.
The hose should have a diameter of 8-10 mm. The recommended length of the
hose must not exceed 1.5 m. The fl exible hose should comply with the relevant
standard and local regulations.
Installation
After purchasing a suitable gas bottle, you can set it up with your gas grill.
•
Change the gas cylinder away from any source of ignition.
•
Position the gas bottle on the left side of your gas grill or place it in the gas
bottle compartment inside the barbecue. Make sure that the gas bottle is
protected from heat and stored in a safe position.
•
When your gas grill is ready for use, insert the regulator into the valve of the
gas bottle and tighten it fi rmly.
WARNING
Risk of injury and damage to property! Before attempting to light
your gas grill, read and understand all instructions, warnings, and
safety precautions outlined in this owner's manual.
EN
39
Publicidad
