Descargar Imprimir esta página

Franke FCBI 1204 C X Instrucciones Para El Uso Y La Instalacion página 8

Ocultar thumbs Ver también para FCBI 1204 C X:

Publicidad

Idiomas disponibles

Idiomas disponibles

USE
L
Button Led
Function
L
-
Turns the lights ON/OFF at maximum strength.
Press and hold for approx. 2 seconds to turn the lighting system on and off at reduced intensity.
T1
Fixed
Turns the motor on/off at speed one.
Delay function:
Press and hold the button for approx. 3 seconds to Activate/Deactivate the Delay function
(automatic switching off of the Motor, the Fans and the Lighting with a 30' delay).
Cannot be enabled when Intensive or 24h are on.
T2
Fixed
Turns the Motor on at speed two.
Press and hold the button for approximately 5 seconds, with all the loads turned off (Motor and Lights),
to turn the Activated Charcoal Filter alarm on. The relevant LED flashes twice to confirm.
To turn the alarm off, press the button again and hold for at least 5 seconds. The relevant LED flashes
once.
T3
Fixed
Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads turned off (Motor and Lights),
to perform a reset. The LED S1 flashes three times.
T4
Fixed
Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system returns automatically to the
speed that was set before. If it is activated with the motor turned off, it will switch to OFF at the end of
the time.
Press and hold for 5 seconds to enable the remote control, indicated by the LED flashing twice.
Press and hold for 5 seconds to disable the remote control, indicated by the LED flashing just once.
S1
Fixed
Signals the Metal Grease Filter saturation alarm, indicating that it is necessary to wash the filters. The
alarm is triggered after the Hood has been in operation for 100 working hours.
Flashing
When this is activated, it signals the Activated Charcoal Filter saturation alarm, indicating that the filter
must be changed; the Metal Grease Filters must also be washed. The Activated Charcoal Filter satura-
tion alarm comes into operation after the Hood has been working for 200 hours.
EN
T1
T2
T3
T4
S1
F
L
T1
Control panel
S1
S1
L
T1
T2
2
3
I
T2
T3
T4
T4
T3
8
8

Publicidad

loading