cecotec conga 8090 ULTRA Manual De Instrucciones página 38

ENGLISH
Note
- Take the robot to the charging base if the battery is low. The robot might not turn on if the
battery is very low.
- The robot will automatically turn on when placed on the charging base.
- The robot cannot be turned off during charging.
Water tank installation
Note
It is not suggested to use the scrubbing function for the first-time use.
- Open the tank's blue silicone lid, fill the tank with water carefully so water does not come
out and close it again. Make sure the silicone clip is properly closed to avoid water from
pilling. Do not immerse the appliance. Fig. 8.
- Install the tank in the robot following the indicated direction. Make sure the clip is properly
fastened. Fig. 9.
- Manually press the tabs on both sides of the Wet & dry tank and push it into its correct
position. You will hear a click when it is properly fixed. Fig. 10.
Recommendations
- Do not use the scrubbing function while the robot is unattended.
- Remove the mop bracket when the robot is charging or not in use.
- If there are carpets in the house, set Restricted Areas to avoid the robot from passing over
them.
- Add some drops of cleaning agent (not corrosive) if considered necessary.
- To remove the mop bracket, press the release button and pull from it outwards.
Warnings
- Using cleaning agents in excess might block water outlets.
- In order to achieve perfect scrubbing, it is suggested to moisten the mop before using it.
First cleaning
- Once the robot and the charging base are completely installed, follow these steps before
scheduling the first cleaning cycle.
- First of all, the robot must be fully charged. It is suggested to allow the robot to charge
overnight. When it is fully charged, it may carry out the first cleaning cycle and save the
first map. To do so, activate Auto cleaning mode and Eco power level. It is very important
to follow these indications for the robot to recognize each and every corner in the house
and to create a complete map.
- If the house where the robot is going to be used is too big and the robot runs out of battery,
do not worry. The robot returns to the charging base, saves the full map and those that
have not been completed, and once it is charged again, it resumes the cleaning cycle from
38