cecotec conga 8090 ULTRA Manual De Instrucciones página 45

Manual mode
- To carry out manual cleaning, use the direction buttons on the remote control or on the App
to take the robot to the specific points where you want it to clean.
- It can be activated from the App or the remote control.
Back home mode
- Select this mode at any point of any cleaning cycle and during any of the modes, the robot
will automatically return to the charging base.
- It can be activated from the robot, the remote control or the App.
Smart area mode
- Once the home's map has been saved, select this mode for the robot to clean a specific
area in zigzag motion. The robot will clean the selected area and then will return directly
to the charging base. You can set more than 1 area at the same time. The robot will only
clean the area selected in the map, therefore it will go to the point and return to the base
without vacuuming.
- It can only be activated from the App.
Spot mode
- Select this mode if you want to thoroughly clean a specific point in the map, making the
most of the robot's maximum power. The robot will clean a 2x2 m zone in zigzag motion
and then will return directly to the charging base when cleaning is completed. The robot
will only clean the area selected on the map, therefore it will go to the point and return to
the base without vacuuming.
- It can only be activated from the App.
Restricted area mode
- Select this mode and delimit in the map specific areas where you do not want the robot to
clean. You can set more than 1 restricted area at the same time on the map.
- It can only be activated from the App.
Twice mode
- Use this mode to carry out a deep, thorough cleaning of your home.
- It can be combined with Edge, Spiral, Spot or Smart Area modes. The robot will carry out 2
full cleaning cycles and then will return directly to the charging base.
Final cleaning
Before returning to the charging base, the robot moves forward and backward several times in
order to eliminate any rests of dust from the brush.
ENGLISH
45