cecotec conga 8090 ULTRA Manual De Instrucciones página 46

ENGLISH
6. CLEANING AND MAINTENANCE
Main brush
- Turn the robot around and press the main brush's release button to take the cover out.
- Take the main brush out and clean the compartment.
- Clean the main brush with the provided tools and use water and soap if necessary.
- Place the main brush in its position and fasten the cover's clip.
Recommendation
Replace the main brush every 6-12 months to ensure efficient operating (depending on the
frequency and type of use).
Fig. 21.
- Main brush cover
- Tab
- Main brush
- Compartment
Silicone brush.Fig. 22.
To clean the silicone brush, follow the instructions on the previous section to remove it from
the robot and wash it with water and soap. Dry it thoroughly before assembling it back in order
to ensure efficient operation.
Jalisco brush.Fig. 23.
To clean the Jalisco brush, follow the previous section's steps to take it out and clean it with
water. Dry it thoroughly before assembling it back in order to ensure efficient operation.
Dust tank.Fig. 24.
- Take the dust tank out.
- Open the dust tank cover and empty it.
- Use the cleaning brush to clean the inside of the dust tank.
- Install the dust tank back in the robot.
- Empty it again before installing it back in the robot.
High-efficiency filter.Fig. 25.
Remove the high-efficiency filter and shake it to remove all the dust.
Note
- Replace the high-efficiency filter every 3 months depending on the frequency and type of
use.
- Clean the filter periodically with a brush to avoid blockage. Do not use water or detergents.
46