cecotec conga 8090 ULTRA Manual De Instrucciones página 41

will automatically plan the cleaning route as it is cleaning. If during this mode the robot
is controlled manually, the robot will calculate the route again and could go through
previously cleaned areas. In order to ensure efficient cleaning, do not operate it manually
during auto mode cleaning.
- Thanks to its Total Surface 3.0 technology, if the battery is low during the cleaning cycle, the
robot will smartly return to the charging base automatically and, once it is fully charged, it
will resume the cleaning process from the same point, offering a high-efficiency cleaning.
During cleaning, the robot will stop briefly to evaluate the area and calculate the cleaning
route (this stop will vary depending on the house conditions).
Note
The robot cleans in an organised way and per 4x4 m squared areas, therefore it might leave
the room where it is cleaning to finish off the delimited area. Do not worry, the robot will clean
all the accessible surface.
Edge mode. Fig. 14.
Press the Edge mode button on the remote control for the robot to start cleaning under this
mode. It will automatically start cleaning along all the surface's perimeters and then will
return to the charging base direct and automatically. If the robot has not started cleaning from
the charging base, it will return to the starting point.
Note
Press the power levels button to switch between the 3 modes: Turbo/Normal/Eco.
Back home Mode. Fig. 15.
- Press the Back home button on the remote control in order to send the robot to the
charging base. This function can be activated during any other cleaning cycle and the robot
will automatically return to the charging base and stop the cleaning process. The robot will
take the shortest route back to the charging base thanks to its map memorizing and the
smart back home function.
- When a cleaning cycle has been completed or the robot's battery is low, thanks to its Total
Surface 2.0 technology, the robot will also return to the charging base to avoid running
out of battery. Once the robot has recharged, it will resume cleaning from the point it has
stopped.
Warnings
- Remove the Wet & dry tank from the robot before charging it.
- Make sure there are no obstacles in the room being cleaned to ensure the robot can get to
the charging base without problems.
Functions
Pause
ENGLISH
41