Descargar Imprimir esta página

cecotec conga 8090 ULTRA Manual De Instrucciones página 39

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
the point it has stopped until it maps the whole surface. The robot keeps on mapping
constantly, therefore it adapts independently to each house's features and continuously
improves previous maps.
4. OPERATION
-
Once the robot's light indicator changes from oscillating orange to steady blue, the battery
is fully charged and the robot is ready to operate.
-
The robot cannot operate with low battery.
Recommendations
-
Remove all cables and obstacles from the floor before operating the robot in order to avoid
accidents and damage.
-
Set stairs as restricted areas.
Robot buttons.Fig. 11.
Automatic mode
Press the power button on the robot for it to start cleaning automatically, first a cleaning
cycle in Edge mode and then another cycle in an organised zigzag motion, recognising
which areas it has cleaned and which ones it has not. The robot will automatically plan
the cleaning route as it is cleaning. If during this mode the robot is controlled manually,
the robot will calculate the route again and could go through previously cleaned areas. In
order to ensure efficient cleaning, do not operate it manually during auto mode cleaning.
Thanks to its Total Surface 3.0 technology, if the battery is low during the cleaning
cycle, the robot will smartly return to the charging base automatically and, once it is
fully charged, it will resume the cleaning process from the same point, offering a high-
efficiency cleaning. During cleaning, the robot will stop briefly to evaluate the area and
calculate the cleaning route (this stop will vary depending on the house conditions).
Note
The robot cleans in an organised way and per 4x4 m squared areas, therefore it might leave
the room where it is cleaning to finish off the delimited area. Do not worry, the robot will clean
all the accessible surface.
Back home mode
-
Press the back home button.
-
This mode can be activated during any other cleaning cycle and the robot will stop cleaning
and return to the charging automatically.
-
The robot will take the shortest route back to the charging base thanks to its map
memorizing and the smart back home function.
ENGLISH
39

Publicidad

loading