cecotec conga 8090 ULTRA Manual De Instrucciones página 42

Idiomas disponibles

ENGLISH

While the robot is operating, press the power button on the App, the remote control or on the

robot to pause it and press the same button again to resume cleaning.

Standby

The robot will automatically enter standby mode after 5 minutes of no operation.

Press the power button on the App, the remote control or on the robot to start it up again.

Warnings

After 12 hours of no operation, the robot will turn automatically off.

The robot will not enter standby mode during charging.

Suction power level

Press the power levels button on the remote control to select the desired power level.

Choose between Eco (low power), Medium (medium power) and Turbo (high power).

Scheduling

Warnings

The robot cannot be scheduled from more than one device at a time. Make sure to schedule

it either from the mobile phone App or from the remote control.

The robot is provided with a schedule function in order to provide a maximum-efficiency

cleaning. The time settings and the cleaning scheduling must be carried out from the

remote control. Once the robot has been scheduled, it will automatically carry out the

cleaning cycles every scheduled day.

Note

Make sure the robot is activated and that the light indicator is on before scheduling any

cleaning or setting time.

Current time. Fig. 16.

Hold down the time button for 3 seconds. The first 2 digits, indicating the hour, will start

blinking.

Use the up and down direction buttons to set the current time. Then, use the left and right

buttons to switch from hours to minutes and repeat the before step. Fig. 17.

Press the time button again to save the settings.

Scheduling cleaning tasks

Hold down the schedule button for 3 seconds. The first 2 digits, indicating the hour, will

start blinking. Fig. 18.

Use the up and down direction buttons to set the schedule time. Then, use the left and

right buttons to switch from hours to minutes and repeat the before step. Fig. 19.

Press the schedule button again to save the settings.