Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
From this new page you can manage:
• Setp Byp
"Bypass" mode activates based on the temperature:
"Setp Byp" is selectable in a range between 15°C and 30°C (default
18°C).
• MBUS ID (Modbus ID)
In the presence of another installed remote HMI user interface,
you can configure a different address than the default one (for
example 160 - see below for more details).
• Motors speed
It allows to set the speeds of the 2 fans ('1', '2', '3', 'Boost').
• Language
Language selection.
• No Frost
Select "No Frost" from the Installer "use menu" to
access the "No Frost Menu." From here you can choose the
functions that can be activated during the "No Frost"
procedure.
For further details on how to select functions see: "No Frost
Menu" page.
"Modbus ID" page
If more than one HMI control is installed, it is necessary to set the Modbus of each external display like described here below.
1. Change the "MBUS ID" so that it is different than 1 and also different from the value of other HMI controls: insert for example the num-
ber 2 and press √.
2. Disconnect the HRU from the power grid.
3. Connect the additional HMI control.
4. Reconnect the HRU to the power grid.
5. Wait for about 30sec - 1min: the led with the symbol "√" will start flashing.
6. At the end of the process the HRU will go back to normal functioning.
7. Repeat points from 2 to 6 for each HMI control, remember always to set a different MBUS ID for each HMI.
NOTA: after the first start up with the second HMI control connected it is necesary to disconnect the equipment from the power grid and
then connect it back.
SETP BYP
018
MBUS ID
160
SPEED
VSUP1
VEXH1
VSUP2
VEXH2
VSUP3
VEXH3
VSUPB
VEXHB
LANGUAGE
ITA
NO FROST
UN - BALAN.
UN - BALAN.
HEATER
HEATER FORC
[ ▲ ]
[ ▲ ]
[ ▲ ]
[ ▲ ]
[ ▲ ]
55
Publicidad
