Look 695 AEROLIGHT Manual De Montaje página 12

EN
COMPLETE MOUNTING OF THE HEAD FIT 3 HEADSET
The LOOK 695 comes with a Head Fit 3 headset. The difference between this headset
and the first version is the replacement of the rod by a pin. Attention: For the complete
mounting of the LOOK Head Fit headset, it is strongly advised to consult an authorized
LOOK retailer.
Description of the 1"1/2 headset:
Lower part: • Single-piece bearing 36°x 45°, outer diameter 52 mm.
Upper part: • Single-piece bearing 36°x 45°, outer diameter 41mm.
• Bearing compression cone 1 1/8
• Thread insert with two flat sections
• Pin
• Threaded spacer
• Pinhole cap
1 / Put the lower bearing on the fork taking
care to place the inner chamfer on the
fork's cone.
2 / Insert the pivot tube in the tube.
3 / Place the upper bearing in the tube
respecting the mounting direction.
4 / Prepare the thread insert and conical
split ring subassembly as shown in Fig
d and slide it on the fork's pivot up to
the upper bearing. Insert the pin after
mounting the unit.
22
Stem
Rubber spacer
Headset clamping ring
(Pin)
Thread insert
Compression cone
Upper bearing
Rubber cap
HEAD TUBE
Lower
bearing
Fork
Fig. c
COMPLETE MOUNTING OF THE HEADSET (continued)
5 / Place the thread insert's drill hole facing the fork's
Fig. d
Pin drilling
At this stage, the fork with its headset and the frame
form a single subassembly. The rest of the mounting
allows setting the headset's functions and fixing the
steering station's elements (spacers composites,
stem...).
6 / Tighten the spacer on the thread insert and adjust the
headset so that there subsists no play and that the fork can freely rotate without any hard
point.
Once the spacer tightened, the pin is imprisoned and mechanically stops it from exiting.
Insert the two rubber caps to fill the gaps in the tube.
At this stage, the fork is mounted adjusted on the frame and the mounting of the other
elements can in no case modify the headset's
settings. There remains the mounting of the
stem at the desired position.
7 / if necessary place the spacer ring according
to the desired stem height
8 / Proceed to the mounting of the Aerostem (see
the manual)
drill hole, and insert the pin through the hole. Make
sure it is well centred; it should not overlap the
thread insert so as not to restrict the spacer's
tightening.
Pivot tube
Rubber Spacer
Carbon Spacer
EN
Fig. e
Stem
Head tube
23