Publicidad
Idiomas disponibles
Idiomas disponibles
Routine Maintenance
EN
Filter
1. Remove the filter and tap its basket gently.
Note: Do not attempt to clean the filter with a brush, a finger or sharp objects to
prevent damage.
2. Rinse the dust bin and filter with water and dry them completely before
reinstalling.
Note:
·
Rinse the dust bin and filter with clean water only. Do not use any detergent.
·
Use the dust bin and filter only when they are completely dry.
20
Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft, dry cloth:
·
The cliff sensors and the carpet sensor on the bottom of the robot
·
Charging contacts at the back of the robot
·
The edge sensor on the side of the robot
·
LDS on the top of the robot
·
The bumper, on the front of the robot
Cliff Sensors
24h
Note: Wet cloth can damage sensitive elements within the robot and the base
station. Please use dry cloth for cleaning.
Routine Maintenance
Charging Contacts
Clean the charging contacts and the signaling area of the base station with a
soft, dry cloth.
Laser Distance Sensor (LDS)
Edge Sensor
Bumper
Charging Contacts
Auto-empty Vents
Clean the auto-empty vents of the robot and the base station with a soft, dry
cloth.
Carpet Sensor
Mop Pad
Remove the mop pad from the mop pad holder to replace it.
Battery
The robot contains a high-performance lithium-ion battery pack. Make sure
that the battery remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of time,
turn it off and put it away. To prevent damages from over-discharging, charge
the robot at least once every three months.
EN
21
Publicidad
