Dreame Bot L10 Ultra Manual Del Usuario página 9

Connecting with Dreamehome App
EN
This product works with the Dreamehome App, which can be used to
control your device.
Scan the QR code on the robot, or search " Dreamehome" in the app store to
download and install the app.
2. Add Device
Open the Dreamehome App, tap " " in the upper right corner, and scan
the QR code above again to add "DreameBot L10 Ultra". Please follow the
prompts to finish the Wi-Fi connection.
My Devices
Note:
Scan QR code on the device
• Only 2.4GHz Wi-Fi is supported.
• Due to upgrades in the app software, the actual operations may be different
Add Device
from the statements in this manual. Please follow the instructions based on the
Scan QR code to connect.
current app version.
12
3. Reset Wi-Fi
Simultaneously press and hold the buttons and until you hear a voice
prompt saying, "Waiting for the network configuration." Once the Wi-Fi
indicator is blinking slowly, the Wi-Fi has been successfully reset.
Wi-Fi Indicator
· Blinking slowly: To be
connected
· Blinking quickly: Connecting
· On: Connected
Note: If your robot cannot connect to the app successfully, reset the Wi-Fi and add
the device again.
How to Use
Fast Mapping
After configuring the network for the first time, follow the instructions on
the app to quickly create a map, and the robot will start mapping without
cleaning. The mapping process will be completed when the robot returns to
the station, and the map will be saved automatically.
Turn On/Off
Press and hold the button for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the base, the robot
should turn on automatically and begin charging. To turn off the robot, move
the robot away from the base and press and hold the button for 3 seconds.
Pause/Sleep
When the robot is running, press any button to pause it.
If the robot is paused for more than 10 minutes, it automatically enters sleep
mode. The power indicator and charging indicator will turn off. Press any
button on the robot or base, or use the app to wake up the robot.
Note:
· The robot will turn off automatically if it is left in the sleep mode for more than 12
hours.
· If the robot is paused and placed onto the base station, the current cleaning
process will end.
Do Not Disturb (DND) Mode
When the robot is set to the Do Not Disturb (DND) mode, the robot will be
prevented from resuming cleaning and the power indicator goes out. The
DND mode is disabled by default at the factory. You can use the app to enable
the DND mode or modify the DND period. The DND period is 22:00-8:00 by
default.
Note:
· The scheduled cleaning tasks will be performed on time during the DND period.
· The robot will resume cleanup where it left off after the DND period expires.
Spot Cleaning
When the robot is on standby, press briefly the button to enable the spot
cleaning mode. In this mode, the robot cleans a square-shaped area of 1.5 ×
1.5 meters around it and returns to its starting point once the spot cleaning is
completed.
Robot Restarting
If the robot stops responding or cannot be turned off, press and hold the
button for 10 seconds to forcefully turn it off. Then, press and hold the
button for 3 seconds to turn the robot on.
EN
13