Vermeiren Sedna Manual De Instrucciones página 20

EN
NL
Follow the instructions for charging:
1. Switch the scooter OFF.
2. FIRST connect the charger to a 230V AC power socket. The indicator goes on (green) to show
that the charger is powered. If not, check the charger's manual before connecting it to the
battery. If the indicator lights alternating in green and red, there is some fault. Do not use the
charger.
3. Slide/turn the cover (19) of the charging point on the
battery open.
4. Connect the battery to the charger. During charging lights
the indicator red.
5. Wait till the battery is fully loaded. The indicator light turns
green again.
6. Disconnect the battery and slide the cover plate back in
place.
7. Switch the scooter on and check if all lights of the battery
status indicator are on.
8. Remove the charger from the socket, let it cool down and
store it on a dry location.
Depending on battery condition, it will be charged after 4 up to 10 hours. Charging for a longer
period won't harm the battery; but do not charge for more than 24 hours. By daily use of your
scooter we recommend to charge the batteries for 8 to 10 hours after use.
When the battery does not charge properly, the charging will stop after 5 hours and the status
indicator will blink every second. Further charging is of no use.
The charging process can be stopped or started any time by following the instructions above.
Connection point for battery charger
18
Sedna
2023-05
Using your scooter
19