Miracle-Ear CHARGE fullpower RIC/BTE T AV Manual Del Usuario página 7

Troubleshooting
SYMPTOM POSSIBLE CAUSES
No LED indicator when
hearing aid inserted
Dead battery
into the charging port
(contd.)
Red blinking LED
Fault occurred
by charging port
12
SOLUTIONS
Connect the microUSB
to your charger and
plug it into the wall.
The on-board battery
LEDs will turn on for a
few seconds to indicate
connection to the
power source. If they
do not, contact your
Miracle-Ear ® Hearing
Care Professional.
Remove the hearing
aid from the charging
port, wait until the LED
turns off and reinsert.
If the red, blinking LED
persists, contact your
Miracle-Ear ® Hearing
Care Professional.
SYMPTOM POSSIBLE CAUSES
Hearing aids
whistling in the Incorrect orientation
charger
Hearing aid whistling
Dead battery
in the charger
Troubleshooting
SOLUTIONS
Reposition your hearing
aid in the port with
the earbud/earmold
pointed out over the
edge of the charger.
There is not a right and
left port, your hearing
aid will charge in either
port. Confirm that the
charging LED begins to
glow.
The charger on-board
battery has died. Plug
in your charger. If you do
not have the cord with
you, push and hold the
hearing aid's rocker
switch for three seconds
to turn it off. This will
conserve the charge in
your hearing aid.
13