Machine Operation; Draining Recovery Tank - Tennant NOBLES EX-SPOT-2 Manual Del Operario

OPERATION
EN
6. Connect hand tool hoses to extractor. Be certain
that coupler locks into extractor's couplers
(Figure 4).
7. Use Spot Remover Kit to remove as much of stain
or spot as possible. (Kit sold separately #111002).

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Turn machine on, switch is located on back panel
of machine.
ATTENTION: If using a cleaning solution, always
test upholstery for color fastness in a hidden place.
2. Place hand tool on spot and squeeze trigger while
pulling back on hand tool (Figure 5).
NOTE: Oversaturating upholstery can lead to prolonged
drying time.
WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
3. Check recovery level periodically. When recovery
tank reaches level as shown, shut machine off and
drain tank (Figure 6).
6
FIG. 4
FIG. 5
ATTENTION: Do not continue to run machine after
recovery tank reaches level as shown. This will
damage the vacuum motor; not covered by
warranty.

DRAINING RECOVERY TANK

1. Turn machine off and unplug power cord.
FOR SAFETY: Before leaving or servicing machine,
turn off machine and unplug cord from wall outlet.
2. Disconnect vacuum hose from recovery tank.
Unfasten latches and lift recovery tank off solution
tank. Drain recovery tank completely and flush it
several times with clean water to remove all dirt left
in tank. This will prevent odor buildup
(Figure 7).
3. Tip solution tank upside down over a sink to drain
any unused cleaning solution. If you used a
chemical in solution tank, flush tank with clean
water to remove excess suds. This will prevent
chemical buildup.
FIG. 6
FIG. 7
EX- SPOT- 2 / EX- SPOT- 8 (04- 10)