Publicidad
Idiomas disponibles
Idiomas disponibles
Extended Battery Module Wiring
R R e e m m o o v v i i n n g g t t h h e e E E B B M M f f r r o o m m t t h h e e D D I I N N R R a a i i l l
1.
Turn off the DC UPS and ensure that DC mains power is disconnected.
2.
Disconnect DC wiring between the DC UPS and the extended battery module DC wiring connections first.
3.
If multiple EBM's are to be disconnected, disconnect wiring between each EBM.
4.
Pull down the on the DIN rail clamp with a flathead screwdriver or tool to release the clamp.
5.
Tilt the EBM slightly and up to remove from the DIN rail.
4 4 . . 2 2
E E x x t t e e n n d d e e d d B B a a t t t t e e r r y y M M o o d d u u l l e e W W i i r r i i n n g g
Only qualified service personnel (such as a licensed electrician) should perform the electrical installation. Risk of
electrical shock.
The DC mains power must be turned off before connecting or disconnecting wires to the battery terminals.
To install the DC input / output wiring to the UPS:
10
Eaton Din Rail UPS Advanced User Guide 934139—Rev A
Hook to top of the DIN rail
Pull down on DIN rail clamp to release
Publicidad
