Publicidad
Idiomas disponibles
Idiomas disponibles
C C h h a a p p t t e e r r 6 6 C C o o m m m m u u n n i i c c a a t t i i o o n n s s
6 6 . . 1 1
U U P P S S D D r r y y C C o o n n t t a a c c t t s s
The DC UPS supports Remote On/Off with Normally Closed signaling and Event Alarm notifications via dry-
contact Normally Open signaling. The user must supply 26 AWG wire to support the length of the installation.
To connect to the UPS contacts:
1.
Strip insulation to 0.35 inches (9mm) of exposed copper wire.
2.
Insert each wire into the appropriate circular terminal slot(s) appropriate for your application. Press in firmly
to lock in place.
3.
Slightly tug to ensure a secure wire insertion.
4.
To remove a wire from contact terminal, insert a small insulated screwdriver into the square hole to the
right of terminal to release.
Terminal voltage and current ratings needed.
Remote and Contact Alarm Pinout
PIN 1
PIN 2
PIN 3
PIN 4
PIN 5
PIN 6
PIN 7
PIN 8
PIN 9
PIN 10
Eaton Din Rail UPS Advanced User Guide 934139—Rev A
Remote On/Off
Ground
On Battery
Common Signal
Replace Battery
Common Signal
Missing Battery
Common Signal
Low Battery
Common Signal
15
Publicidad
