Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the UPS to the DIN Rail
R R e e m m o o v v i i n n g g t t h h e e U U P P S S f f r r o o m m t t h h e e D D I I N N R R a a i i l l
1.
Turn off the DC UPS and ensure that DC mains power is disconnected.
2.
Disconnect DC wiring between the DC UPS and any extended battery module DC wiring connections first.
3.
If multiple EBM's are to be disconnected, disconnect wiring between each EBM.
4.
Pull down the on the DIN rail clamp with a flathead screwdriver or tool to release the clamp.
5.
Tilt the UPS slightly and then up to remove from the DIN rail.
Figure 4. Removing UPS From DIN Rail
6
Eaton Din Rail UPS Advanced User Guide 934139—Rev A
Hook to top of the DIN rail
Pull down on DIN rail clamp to release
Publicidad
