Cleaning And Maintenance; Belt And Running Deck; Lubrication (Fig. F-4) - Tunturi T10 Manual Del Usuario

product. Furthermore, the warranty does not
cover defects arising from usage and storage
within an unsuitable environment as described
within the Owner's Manual which should be
indoors, dry, dust and grit free and within a
temperature range of +15°C to +35°C. The
warranty does not cover maintenance activities,
such as cleaning, lubricating, and normal part
adjustments, nor installation
procedures that customers can accomplish
themselves, such as changing uncomplicated
meters, pedals and other similar parts not
requiring any dismantling/reassembling of the
fitness equipment. Warranty repairs carried out
by other than authorised Tunturi representatives
are not covered.
Failure to follow the instructions given in the
Owner's Manual will invalidate the product's
warranty.
Cleaning and mainte-
nance
WARNING
• Before cleaning and maintenance, remove
the mains plug from the wall socket.
• Do not use solvents to clean the
equipment.
- Do not block the ventilation openings. Keep
the ventilation openings clear from dust, dirt
and other obstructions.
- Clean the equipment with a soft, absorbent
cloth after each use.
- Clean the visible parts of the equipment with
a vacuum cleaner with a small suction nozzle
- Regularly check that all screws and nuts are
tight.

Belt and Running Deck

Your treadmill uses a very high-efficient low-
friction bed. Performance is maximized when
the running deck is kept as clean as possible.
Use a soft, damp cloth or paper towel to wipe
the edge of the belt and the area between
the belt edge and frame. Also reach as far as
practical directly under the belt edge. This
should be done once a month to extend belt
and running deck life. Use water only - no
cleaners or abrasives. A mild soap and water
solution along with a nylon scrub brush will
clean the top of the textured belt. Allow the
belt to dry before using.

Lubrication (fig. F-4)

The running belt must be checked for
lubrication once per 2 months, based on the
average use of 60 minutes per day.
WARNING
• Before lubrication, remove the mains plug
from the wall socket.
CAUTION
• Only lubricate the running belt if
necessary. If you apply too much lubricant,
the running belt will slip easily due to lack
of friction.
- Stand steadily on the running belt.
- Take hold of the front handlebar and push
the running belt with your feet so that it
slides back and forth. The running belt must
move smoothly and evenly without making
sound.
- If the running belt does not move smoothly
and evenly or if the running belt does not
move at all, touch the underside of the
running belt with your fingertips to check the
lubrication:
• If you feel lubrication or your fingertips are
shiny, there is sufficient lubrication on the
running belt.
• If you do not feel lubrication or your
fingertips are dusty or rough, apply
lubricant (15-20 ml) in the middle of the
running deck under the running belt and
let the equipment operate at 5km/h for at
least 5 minutes.
• After lubrication, do not fold the
equipment before having done a workout
for 20 minutes with a speed of at least 5
km/h. The lubricant will be spread evenly
over the running belt.
23
English