radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
This product meets the applicable Innovation,
Science and Economic Development Canada
technical specifications.
To comply with FCC and ISED RF radiation
exposure limits for general population / uncontrolled
exposure, the antenna(s) used for this transmitter
must be installed to provide a separation distance
of at least 5 mm from all persons and must not be
colocated or operating in conjunction with any other
antenna or transmitter.
Le présent produit est conforme aux spécifications
techniques applicables d'Innovation, Sciences et
Développement économique Canada.
Le présent appareil est conforme aux
CNR d'Innovation, Sciences et Développement
économique Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
•
l'appareil ne doit pas produire de brouillage, et
•
l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le
fonctionnement.
Suppliers Declaration of Conformity for
™
HusqvarnaXcite
Z350, Xcite
Responsible Party
Husqvarna Professional Product, Inc.
9335 Harris Corners Parkway
Charlotte, NC 28269
United States
Telephone: +1 704 597 5000
E-mail: http://www.husqvarna.com/us/support/e-mail/
Safety instructions for operation on slopes
WARNING:
instructions that follow before you use
the product.
10
™
Z380
Read the warning
Slopes are a major factor related to accidents.
Operation on slopes requires extra caution.
•
Travel in the manufacturer recommended
direction on slopes. Use caution while operating
near dropoffs.
•
Avoid mowing wet grass. The tires can lose
traction.
•
Do not operate product under any condition
where traction, steering, or stability is in question.
Tires could slide even if the wheels are stopped.
•
Always keep the product in gear when going
down slopes. Do not coast downhill.
•
Avoid starting and stopping on slopes. Avoid
making sudden changes in speed or direction.
Make turns slowly and gradually.
•
Use extra care while operating product with a
grass catcher or other attachment(s). They can
affect the stability of the product.
•
To cut grass on slopes increases the risk that
you can not control the product and that it
overturns. This can cause injury or death. It is
necessary to cut the grass carefully on all slopes.
If you cannot reverse up a slope or if you do not
feel safe, do not cut it.
•
Remove stones, branches and other obstacles.
•
Cut the grass on the slope up and down, not
from side to side.
•
Do not operate the product on ground that slopes
more than 10°.
•
Move smoothly and slowly on slopes.
•
Look out for and do not move across furrows,
holes and bumps. There is a higher risk that the
product overturns on ground that is not flat. Long
grass can hide obstacles.
•
Do not cut grass near edges, ditches or banks.
The product can suddenly overturn if a wheel
moves across the edge of a steep slope or a
ditch, or if an edge gives way.
Personal protective equipment
WARNING:
instructions that follow before you use
the product.
•
Use approved personal protective equipment
when you use the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident
does occur. Let your dealer help you select the
right equipment.
•
Use approved eye protection. If you use a visor,
you must also use approved protective goggles.
Approved protective goggles must agree with the
Read the warning
1922 - 006 - 13.12.2022