Husqvarna Xcite Z350 Manual De Usuario página 17

2. Set the cutting deck to the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 16 .
3. Engage the parking brake. Refer to
and disengage the parking brake on page 15 .
4. Move the throttle control (A) to ½ throttle
position.
B
A
5. Put the key (B) into the key switch.
6. Turn the key switch to the unlocked position.
7. Set the control levers in park position.
8. Push and hold the START/STOP button on the
control panel or on the left control lever for
approximately 1–2 seconds to start the engine.
9. Let the engine run at ½ throttle for 3–5 minutes
before you apply full throttle.
10. Push the throttle control to the full throttle
position.
To operate the headlights
1. Make sure that the key switch is in the unlocked
position (A).
A
B
2. Push and hold the headlights button (B) for
approximately 1–2 seconds. The headlights
come on.
3. Push and hold the headlights button for
approximately 1–2 seconds again. The
headlights go off.
To operate the product
1. Start the engine. Refer to
page 16 .
1922 - 006 - 13.12.2022
To engage
To start the engine on
2. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 15 .
3. Carefully push the 2 control levers forward. The
product will start to move forward. The forward
speed increases the more the 2 control levers
are pushed forward.
4. Carefully pull the 2 control levers rearward. The
product will start to move rearward. The rearward
speed increases the more the 2 control levers
are pulled rearward.
5. Put the 2 control levers in neutral position to
decrease the speed and stop the product.
6. Do the steps that follow to turn left or right when
you go in a forward direction.
a) Pull the left control lever rearward in the
direction of the neutral position to make the
product turn left. The more you pull the left
control lever rearward, the more the product
will turn left.
To
17