Publicidad
Idiomas disponibles
Idiomas disponibles
ANSI Z87.1 standard in the USA or EN 166 in
EU countries.
•
Always wear approved hearing protection. Long
term exposure to noise can result in permanent
hearing impairment.
•
Always wear protective shoes or protective
boots. Steel toes are recommended. Do not use
the product barefoot.
•
Wear gloves when necessary, for example
when you attach, examine or clean the cutting
equipment.
•
Do not wear loose-fitting clothing, jewelry or
other items that can get caught in moving parts.
•
Keep first aid equipment and fire extinguisher
close at hand.
Safety devices on the product
WARNING:
instructions that follow before you use
the product.
•
Do not use a product with defective safety
devices. Do a check of the safety devices
regularly. If the safety devices are defective,
speak to your Husqvarna service agent.
•
Do not make modifications on safety devices. Do
not use the product if protective plates, protective
covers, safety switches or other protective
devices are not attached or are defective.
Key switch and key
The key switch is on the control panel. To start the
engine, the key must be in the key switch and the
key switch must be in unlocked position.
To do a check of the key switch and key
•
Start and stop the engine. Refer to
engine on page 16 and To stop the engine on
page 18 .
1922 - 006 - 13.12.2022
Read the warning
To start the
•
If the key switch and key operates correctly, the
engine can only start when the key switch is in
the unlocked position.
Accessory rack
The accessory rack is used for storage and
transportation. The weight limit is 30 lb (13.6 kg).
CAUTION:
•
For transportation of liquids, use
containers that are correctly sealed
and not damaged to prevent spills on
the engine.
•
Attach items to the accessory rack
with straps.
WARNING:
accessory rack as a seat.
Engine START/STOP button
The product has 2 engine START/STOP buttons: 1
on the control panel and 1 on the left control lever.
To do a check of the engine START/STOP buttons
1. Start the engine. Refer to
page 16 .
2. Push and hold the engine START/STOP button
on the control panel for approximately 1–2
seconds and make sure that the engine stops.
3. Start the engine again.
4. Push and hold the engine START/STOP button
on the left control lever for approximately 1–2
seconds and make sure that the engine stops.
Operation conditions
These conditions are necessary to start the engine:
•
The control levers are in the park position.
•
The parking brake is applied.
•
The drive of the blades is disengaged.
The engine must stop in these situations:
Do not use the
To start the engine on
11
Publicidad
