Publicidad
Idiomas disponibles
Idiomas disponibles
Lubrication, general information
•
Remove the ignition key to prevent accidental
movements during lubrication.
•
Clean the area before you lubricate a part on the
product.
•
Use engine oil when you lubricate with an oil can.
•
When you lubricate with grease, use a chassis
or ball bearing grease that prevents corrosion.
Remove unwanted grease after lubrication.
•
Lubricate 2 times a week if you operate the
product daily.
•
Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean
with alcohol. If the friction between the drive belt
and the pulley is not sufficient after you clean
with alcohol, replace the drive belt.
CAUTION:
other petroleum products to clean drive
belts.
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
The engine does not start.
The starter motor does not turn the engine
over.
26
Do not use gasoline or
Troubleshooting
Cause
The drive of the blades is engaged. Refer to
Off) button and LED indicator on page 5 .
Steering controls are not locked in the neutral position.
The battery is too weak. Refer to
21 .
There is dirt in the carburetor or fuel line.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
The battery is too weak. Refer to
21 .
The connection at the cable connectors on the battery terminals
is bad. Refer to
A fuse is blown. Refer to
The OPC is defective. Refer to
(OPC) on page 6 .
To lubricate the cutting deck
spindles
1. Set the cutting deck in mow position.
2. Lubricate each cutting deck spindle 2-3 strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
To charge the battery on page
To charge the battery on page
To clean the battery on page 21 .
Fuses on page 6 .
Operator Presence Control
PTO (Power Take-
1922 - 006 - 13.12.2022
Publicidad
