Husqvarna Xcite Z350 Manual De Usuario página 25

1. Lift the rear of the product and put supports
below it.
2. Remove the drive wheels.
3. Remove the deck belt. Refer to
deck belt on page 24 .
4. Remove the clutch stop to get access to the
pump belt.
5. Loosen the nuts on the eye bolt to decrease the
tension in the pump belt.
6. Remove the pump belt from the engine and the
pump pulleys.
To install the pump belt
1. Loosen the nuts on the eye bolt to decrease the
tension in the pump belt.
2. Put the pump belt around the right and left pump
pulleys.
3. Put the pump belt around the engine pulley.
4. Install the clutch stop.
5. Turn the nut on the eye bolt on the idler pulley to
adjust the tension of the pump belt. The length of
the spring must be 1.38–1.50 in.
6. Install the deck belt. Refer to
belt on page 24 .
7. Install the drive wheels.
8. Remove the supports and lower the rear of the
product.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Loosen the dipstick and pull it out.
3. Clean the oil from the dipstick.
4. Put the dipstick in the hole for the dipstick and
tighten it.
5. Loosen and pull the dipstick out and read the oil
level.
1922 - 006 - 13.12.2022
To remove the
To install the deck
6. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil
to the FULL mark.
7. Fill the oil through the hole for the dipstick. Fill
the oil slowly.
Note:
Technical data on page 31
Refer to
for the types of engine oil that Husqvarna
recommends. Do not mix different types of oil.
8. Tighten the dipstick fully before you start the
engine.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the
engine oil warm and faster to drain.
WARNING:
engine for more than 1–2 minutes before
you drain the engine oil. The engine oil
becomes very hot and can cause burn
injuries. Let the engine become cool
before you drain the engine oil.
WARNING:
your body, clean with soap and water.
1. Park the product on level ground and stop the
engine.
2. Engage the parking brake. Refer to
and disengage the parking brake on page 15 .
3. Remove all dirt around the oil tank cap.
4. Remove the oil tank cap and the dipstick.
5. Find the oil drain plug on the engine. Refer to
Product overview on page 3 .
6. Put a container below the oil drain plug.
7. Remove the oil drain plug.
8. Let the oil run out into the container.
9. Replace and install the oil drain plug.
10. Fill with new oil and do a check of the engine oil
To do a check of the engine oil
level. Refer to
level on page 25 .
11. Install the oil tank cap and the dipstick.
Note:
For safe disposal of used engine oil, refer to
Disposal on page 30 .
Do not operate the
If you spill engine oil on
To engage
25