Vortice METAL DRY Folleto De Instrucciones página 9

ENGLISH
!
Caution:
this symbol indicates caution messages aimed at avoiding personal injury
to the user
• Do not use this appliance for any application other
than that stated in this booklet.
• After removing the appliance from its packing, make
sure that it is intact: if in doubt consult a qualified
professional or Vortice*. Do not leave packing
materials within the reach of children.
• Do not operate the appliance in presence of
!
Precaution:
• Do not make any modifications of any kind to your
unit.
• The unit must not be exposed to atmospheric
conditions (rain, direct sunlight, etc.).
• Install the unit following these instructions (fig. 3).
• Do not cover or obstruct the unit's inlet grille or
outlet nozzle.
• Site the automatic hand dryer carefully to avoid
interference during operation.
• Since the unit is double insulated, it does not need
to be earthed. Regularly inspect the unit. Should the
unit suffer damage, fail to operate correctly, or if a
fault is found, switch off the supply, and contact
Vortice*. Always make sure that original Vortice
spare parts are used.
• The unit must be installed by a suitably qualified
electrician.
• The installation and wiring must conform to current
IEE Regulations (UK) local or appropriate
regulations (other countries). It is the installer's
responsibility to ensure that the appropriate Building
Codes of Practice are adhered to.
• When installing the unit, a double pole isolation
isolation switch must be fitted with a minimum
contact gap of 3mm.
• Ensure that the main supply is switched off before
making any electrical connections or carrying out
The mains supply must conform with the
specifications shown on the plate A.
this symbol indicates precautions which should be taken to avoid damage
to the product
inflammable vapours (alcohol, insecticides, petrol,
etc.).
• Do not place any object on the unit.
• The appliance is not intended for use by young
children or infirm persons without supervision.
• Young children should be supervised to ensure that
they do not play with the appliance.
maintenance or cleaning.
• The rubber grommet in the base of the unit is
suitable for supply cables of between ø 7 mm and
14 mm (fig. 6A-7A-6B). Alternatively the rubber
grommet can be removed and a rigid tube of
ø 16 mm (Helios or equivalent model) can be fitted
(fig. 6C).
• The units have an internal trimmer which can be
adjusted as follows: automatic models, the trimmer
can be used to adjust the sensitivity of infrared
sensor (Fig. 23); on manual version it can instead be
used to increase or decrease the drying time (Fig.
23A). Adjustment operations should be performed
during installation.
Note:
• If the unit overheats, the power supply will
automatically cut out, and will only be restored
when the temperature drops back to normal
levels. If this first cut-off device malfunctions, a
second protection device will cut in and turn off
the power.
• Both the Automatic models are equipped with
an anti-vandalism device that switches off the
unit after 5/10 minutes of continuous operation.
Operation will resume automatically after the
blockage has been removed.
• Automatic models have an over-run timer set
between 2 and 5 seconds.
* (or an authorised Service Centre if you are outside
the UK-Ireland territory)
9