Publicidad
Idiomas disponibles
Idiomas disponibles
Getting started
Reset Button
The Reset button has two functions:
1) To enter Administrator Mode. Press the Reset button once. Pressing the Reset button again will allow you to exit
the Administrator Mode. Changes made to registers during this time will be saved after exiting Administrator Mode
using the Reset button.
2) To reset the washer to factory settings. Press and hold the Reset button for at least 6 seconds. NOTE: All
parameter settings in Administrator Mode will be restored to default factory settings. The parameters will be reset to
Multipay Mode (Coin and App) and coin payment pricing will default to zero. The password will be restored to 1234.
The Reset button is located on the back of the user interface board.
To access the Reset button:
1) Remove the dispenser drawer by pulling it out until it stops.
2) Using a tool such as a long screwdriver, press down firmly on
the locking tab located at the rear of the dispenser drawer and
pull the dispenser drawer out.
3) Remove the two screws that are holding the control panel, slide
the control panel to the left and pull it outward.
Payment
mode
In standby state, all LEDs are off and all buttons are invalid in the
beginning.
Once the QR code is scanned, the user can select a cycle on the
unit and pay for the cycle in the mobile app.
App Pay
When the payment is done successfully the selected cycle LED will
be turned on and the Start/Pause button will start flashing to guide
the user to press the button to start the washing cycle.
After the door is closed, press Start/Pause to start cycle.
In standby state, the cycle LED indicator is on, cycle selection
button is valid and the Start/Pause button is invalid.
When the cycle is selected, the relevant cycle indicator LED will
turn on.
User needs to insert coins according to the displayed cycle price.
Coin Pay
The displayed price will decrease as coins are inserted, until the
filled coin value is equal to cycle price.
When the payment is completed successfully, the washer will sound
a beep and the Start/Pause button will flash. If the payment is not
finished in time, the washer will go back to the standby state.
After the door is closed, press Start/Pause to start cycle.
In standby state, the cycle LED is on and cycle selection buttons
are valid.
Multiple
Pay
Select cycle and insert coins or scan QR code to pay.
(Default
See above for expected behaviors once payment is completed.
Payment)
Users cannot combine App and Coin Pay methods on a single
cycle.
49-3000277 Rev 0
Payment Modes
Operation
Reset button location on
Reset Button
SW06
Flashes: "see app".
Remaining cycle time.
Alternately shows prices and
remaining cycle time.
Alternately shows prices and
remaining cycle time.
Alternately shows the price that
should be paid and remaining
Remaining cycle time.
Remaining cycle time.
Alternately shows coin cycle
prices and remaining cycle time.
Flashes: "see app".
back of control panel:
Displays
----
Cycle time.
cycle time.
/
13
Publicidad
