Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
If you have any questions, call GE Appliances at 866.531.9828 or visit our Website at:
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
instructions for future reference.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
LOCATION OF YOUR WASHER
• Install the washer close to a drain standpipe or floor
drain, and within 4 feet of the water supply spigots.
• A minimum of 1" (25mm) clearance is recommended
between units if more than one machine is installed
in a row.
• The floor must be smooth and hard. Do not install the
unit on carpet or other soft material.
• The floor must hold the total weight of the washer
filled with water and a load. The static weight of the
washer is 322 lbs.
• DO NOT install the washer in an area exposed to
dripping water or outside weather conditions. The
ambient temperature should never be below 60°F
(15.6°C) for proper washer operation.
REPLACEMENT PARTS
Inlet Hoses (2)
18
GEAppliances.com/commerciallaundry
Save these
Observe all
Be sure to leave these
Keep these
Rubber Washer and
Strainer Screen (1)
TOOLS REQUIRED
Level
Phillips screwdriver
PARTS SUPPLIED
Inlet Hoses (2)
Gasket (for optional
stacking installations)
Screws (8)
Drain Hose
Drain Hose Guide
GE Appliances Parts and Accessories
Order by phone at 866.531.9828 during normal
business hours.
Part Number
Accessory
WH41X28682
Inlet hoses with 90° elbows; 2-pack
WH1X2267
Rubber Washer and Screen (1)
Washer
Wrench (supplied)
Clamp
Cable Tie
Coin Box Cover
Coin Drop Cover (2)
Access Key
49-3000277 Rev 0
Publicidad
