Publicidad
Idiomas disponibles
Idiomas disponibles
Getting started
Features and appearance will vary.
Controls
COMMERCIAL LAUNDRY
On coin-operated models, a different price can be charged for each cycle, and an additional price can be programmed
for each of the two option buttons. For connected/App Pay units, pricing is changed in the portal. See Administrator
Mode in the Using the Washer section.
Wash Cycles
A
The washer offers four standard wash cycles. The basic wash cycles are Cold, Warm, Hot, and Delicate.
The Cold, Warm and Hot wash cycles are comprised of three segments. These cycles begin with the main
wash which fills to the LOW water level. The water level and duration of the main wash can be adjusted
using the washer's Administrator Mode. The main wash water temperature is cold in the COLD cycle, warm
in the WARM cycle, and hot in the HOT cycle. The main wash fills through the detergent compartment of the
detergent drawer. Approximately half way through the main wash, the bleach compartment of the detergent
dispenser is flushed.
The washer drains following the main wash and refills to the HIGH water level for each of the two cold water
rinses that complete the basic cycles. Each rinse is followed by a drain and spin cycle. The final rinse flushes
the softener compartment of the dispenser.
NOTE: Heavy Soil and Extra Rinse options cannot be used with the Delicate cycle.
Options
B
The optional features are Heavy Soil and Extra Rinse. The options can be added to the basic wash cycles
(except for Delicate), in any combination.
The Heavy Soil option adds a prewash to the cycle. Heavy Soil is not available when the Delicate cycle is
selected.
The Extra Rinse option adds one additional cold water rinse to the wash cycle. Extra Rinse is not available when
the Delicate cycle is selected. The extra rinse repeats the second-to-last rinse. If a second rinse cycle is desired,
refer to Administrator Mode and Register Address for Parameters Setting in the Using the washer section.
Start -
Press to start the wash load.
C
Pause -
While washer is running, press Start/Pause button. The washer will pause the cycle and go into a
pause state. During this time:
• All loads are turned off.
• LED display will show remaining cycle time blinking in one second intervals.
• Machine will transition to "Idle" state and time out four minutes after door is unlocked.
• If LED displays "lock" this means the washer was paused with water in it and the door cannot be opened.
• Press Start/Pause button again to resume the wash cycle.
NOTE: If the machine is paused for more than 4 minutes, the unit will automatically drain, and return to standby
mode. At this point, the cycle selection and payment process must be repeated in order use the machine again.
Display
D
Displays payment amount due, time remaining, and "End" when wash is finished and door can be opened.
49-3000277 Rev 0
A
Cold
Warm
Hot
Delicate
Muy Sucio Enjuage
Frio Templado Caliente Delicado
B
C
Start
Heavy
Extra
Comienzo
Soil
Rinse
Pause
Pausa
D
Price/Time Remaining
Precio/Tiempo
7
Publicidad
