Kärcher 2.200-000.0 WRS 200 Manual De Instrucciones página 19

1.4.3 Licence plate
A licence plate (repeater licence plate) must be attached
before use on public roads.
A damaged blade guard must not be used
Licence plate position
1
2 Warranty
The warranty conditions issued by our relevant sales com-
pany apply in all countries. We shall remedy possible mal-
functions on your appliance within the warranty period free
of cost, provided that a material or manufacturing defect is
the cause. In a warranty case, please contact your dealer
(with the purchase receipt) or the next authorised custom-
er service site.
(See overleaf for the address)
3 Intended use
These operating instructions describe the handling of the
WRS 200 attachment kit.
The attachment kit can be attached to the following vehi-
cles using the corresponding adapter.
 MIC 35/42
 MIC 50/70
 MC 130
The WRS 200 attachment kit is intended for the outdoor
elimination of weeds using a hot water high-pressure
cleaner and associated weeding tools.
The high-pressure cleaner can also be used for cleaning
locations that are difficult to access.
The device may only be connected to the public water sup-
ply via a suitable backflow preventer.
The WRS 200 attachment kit may only be used for the in-
tended use, as illustrated and described in these operating
instructions.
Intended use also includes adherence to the prescribed
maintenance activities and intervals.
The vehicle and attachments may only be used, main-
tained and repaired by persons familiar with the vehicle
and attachments and the associated hazards.
The legally applicable general safety and accident preven-
tion regulations must be adhered to. All other safety regu-
lations, occupational health care regulations and road
traffic regulations must be adhered to.
The operating personnel must:
 Be physically and mentally suitable
 Have been instructed in the handling of the vehicle and
attachments
 Have read and understood these operating instructions
and the operating instructions for the vehicle to which
this attachment kit is attached
 Have provided the operating company with verification
of capability to operate the vehicle
 Be explicitly nominated to operate the vehicle by the op-
erating company
4 Safety instructions
The following safety instructions apply to the device:
 Observe the respectively applicable national regulations
for liquid jet cleaners.
 Observe the respectively applicable national accident
prevention regulations. Liquid jet cleaners must be test-
ed regularly and the results of the test recorded in writ-
ing.
 Note that the heating system in the device is classified
as a furnace. Furnaces must be inspected regularly ac-
cording to the applicable national regulations.
 According to the application national regulations, this
device must be initially commissioned by a qualified per-
son when used commercially. KÄRCHER has already
performed and documented this initial commissioning
for you. You can request the documentation for this from
your KÄRCHER partner. Please provide the part num-
ber and works number of the device when requesting
documentation.
 We explicitly state that the application national regula-
tions require that this device must be inspected regular-
ly by a qualified person. Please contact your KÄRCHER
partner for this.
 No modifications may be made to the device or acces-
sories.
4.1 Battery
ATTENTION
Information on safety, charging, care and disposal of the
battery is provided in the vehicle operating instructions.
Always cover the plus terminal of the battery with the pro-
tective cap.
4.2 High-pressure hose
The following safety instructions apply to the high-pressure
hose:
 Use only original high-pressure hoses.
 The high-pressure hose and the spray unit must be suit-
able for use at the maximum operating pressure speci-
fied in the technical data.
 Avoid contact with aggressive chemicals.
 Inspect the high-pressure hose daily.
Do not continue using kinked hoses. Do not continue us-
ing the high-pressure hose if the outer wire mesh layer
is visible.
 Do not continue using a high-pressure hose with a dam-
aged thread.
 Lay the high-pressure hose so that it cannot be driven
over or presents a tripping hazard to persons.
 A hose that has been driven over, kinked or subjected to
impacts may no longer be used, even if no damage is
visible.
 Store the high-pressure hose in a manner avoiding me-
chanical stresses on the hose.
English 19