Publicidad
Idiomas disponibles
Idiomas disponibles
●
ATTENTION
Observe the regulations at your water dis-
tribution company. The device may only be connected to
the public water supply via a suitable backflow preventer.
4.9
Operation
●
DANGER
When using the device in hazard zones
(e.g. service stations), adhere to the respective safety reg-
●
ulations.
Operation in explosive atmospheres is prohib-
●
ited.
Damaged wheels / tyre valves are extremely
dangerous. Damaged wheels / tyre valves can be dam-
aged by the high-pressure jet and explode. The first sign of
this is discolouration of the tyres. Keep a spray distance of
at least 30 cm when cleaning the wheels / tyre valves.
●
WARNING
Do not use the device if people without
the proper protective clothing are in its reach.
spray lances, your hand may come into contact with the
high-pressure jet. Never use a spotlight nozzle or rotary
nozzle with steel tubes that are shorter than 75 cm.
coil force will arise due to the water stream ejecting from
the spray lance. An angular spray lance produces a force
that acts in upward direction. Make sure you grip the gun
●
and spray lance firmly.
recoil forces and twisting forces may alter.
the high-pressure jet at yourself, e.g. to clean clothes or
●
shoes.
Do not direct the high-pressure jet at persons,
animals, live electrical equipment or at the device itself.
●
Close the doors before driving.
jects which contain harmful substances (e.g. asbestos).
●
Check the device and the accessories, such as the high-
pressure hose, high-pressure gun and safety devices, to
make sure they are in proper safe and reliable condition
before each operation. Do not use the device if it is dam-
aged. Replace damaged components immediately.
use high-pressure hoses, control panels and couplings
specified by the manufacturer.
●
CAUTION
Never leave the device unsupervised
●
while it is in operation.
●
motor is running.
Never clamp the lever of the high-pres-
sure gun during operation.
after hot water operation or operate the device briefly using
●
cold water operation.
The device must be placed on an
●
even, firm subsurface.
assessment of the surface to be cleaned to determine any
health and safety protection requirements. The necessary
protective measures must be taken accordingly.
●
ATTENTION
Do not operate the device at temperatures
●
below 0 °C.
Only clean the motor at washing stations
with an oil separator.
4.9.1 Operation with detergent
●
CAUTION
Keep the detergent out of the reach of
●
children.
When using detergents, observe the safety da-
ta sheet of the detergent manufacturer, in particular in-
structions on protective gear.
supplied or specified by the manufacturer. The use of other
detergents or chemicals can impair the safety of the de-
●
vice.
Should detergents come into contact with eyes,
rinse these out immediately and thoroughly using water
and seek medical attention immediately. The same applies
if detergents are swallowed. Note
be used for spreading pesticides.
4.9.2 Hot water burner
●
DANGER
Explosion hazard due to unsuitable fuel.
Only fill the fuel specified in the operating instructions.
●
With short
When using angular spray units,
●
Do not aim
●
Do not spray any ob-
Never open the cover while the
●
Allow the hoses to cool down
Before cleaning, carry out a risk
●
Only use the detergents
●
The device may not
●
Exhaust gases are toxic. Never breathe in the exhaust
gases. Ensure rooms where the device is operated are
sufficiently ventilated and that exhaust gases can be con-
ducted away.
WARNING
gets on hot surfaces.
CAUTION
exhaust gas opening and never reach inside it. Do not
touch the heating boiler while the burner is in operation.
●
Never close off exhaust gas openings.
no exhaust gases are emitted close to air vents.
serve the safety instructions for petrol-driven devices in the
operating instructions.
4.10 Care and service
WARNING
cleaning, maintenance and replacement of parts.
●
A re-
pressurise the high-pressure system prior to all work on
the device or its accessories.
CAUTION
proved customer service sites or staff qualified in this area
who are familiar with all relevant safety instructions.
ATTENTION
mobile devices for industrial use in accordance with the lo-
cally applicable regulations
age. Do not clean the device with a hose or high-pressure
●
water jet.
Do not use acetone, undiluted acids or sol-
vents, as they corrode the materials used on the device.
4.11 Accessories and spare parts
CAUTION
which are approved by the manufacturer. Only original ac-
cessories and original spare parts ensure that the appli-
●
Only
ance will run fault-free and safely.
installation of spare parts performed by the approved Cus-
tomer Service in order to prevent any hazards.
English
●
During tanking, make sure that no fuel
●
Risk of burns. Never bend down over the
●
Always switch the device off prior to
●
Repairs may only be carried out by ap-
●
Pay attention to the safety inspection for
●
Short-circuits or other dam-
●
Only use accessories and spare parts
●
Only have repairs and
●
Make sure that
●
Ob-
●
De-
21
Publicidad
