Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
How to Add Additional Extender Arms
NOTE: Install Extender Arms with the Frame Rod holes facing up.
To install additional Extender Arms, align the Extender Arm prongs with the
receiver slot of the installed Extender and push the Extender Arm in until
the pivot pins snap into place.
NOTE: A maximum of three Extender Arms on any one corner will be used
during normal setup and operation.
Making Final Extender Arm Adjustments
f. Measure the width between the rod holes on the second set of Angle
Braces to be sure the distance is between 23" and 25" (Fig. 2.4 "C")
g. If the distance is less than needed, adjust each Extender Arm outward
on the Angle Brace by one position and repeat this measurement.
NOTE: Each Angle Brace has adjustment teeth with 5 different positions.
This is to allow the Extender Arms the ability to move into the desired lo-
cation. For many inverters you will start by moving the Extender arms out
to their furthest positions away from the inverter case.
|
12
English
Fig. 2.3
Publicidad
