Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Quick Release of the GenTent
The GenTent can be removed in one piece to facilitate maintenance should
it be needed. This can only be completed after completing steps "3. Install
the GenTent Frame" & "4. Cover the GenTent".
WARNING
less the entire setup is complete. This can cause the system to twist
and mangle and might damage your GenTent.
a. With the GenTent fully installed you can open the ratchet handle by
pinching the release lever, allowing an inch or less of slack through.
b. You will want to release only enough tension on the strap that the as-
sembly will want to fall to the ground.
c. Close the ratchet handle.
d. Take hold of the GenTent by grasping the center of the Canopy top cap
(Fig. 4.5) and lift straight up, DO NOT LIFT BY THE TOP CAP CORNERS.
The tension on the strap from the fully assembled GenTent will ensure
it keeps its shape.
e. Place the fully assembled GenTent to the side while you perform
maintenance.
f. Once maintenance is complete, place the entire assembly back over
the generator back into the desired location and Ratchet Strap tight, as
it was before.
|
18
English
Do not attempt to quick release the GenTent un-
Fig. 4.5
Publicidad
