Westinghouse iGenTent Manual Del Usuario página 6

ASSEMBLY
1. ASSEMBLE AND INSTALL STRAP MOUNT
Understanding the Mounting
Components
The Angle Braces and Extender
Arms work together with the
Kevlar ratchet buckle (Fig. 1.1)
®
to create a stable and strong
mounting point for the GenTent
frame on your inverter generator.
The Kevlar Ratchet Strap (Fig.
®
1.2) is installed through the Angle
Brace center and is tightened to create the
base of the mounting assembly to your
inverter case.
The Angle Braces (Fig. 1.3) are held to the
four corners of your case along with the
Gator Grommets™ by the Kevlar
Strap and creates a firm mounting and
adjustment point for the Extender Arms.
The Gator Grommets™ (Fig. 1.4) are
pressed onto the pins of the Angle Brace
to create a corner mounting assembly.
The grommets allow the assembly to grip
the generator case without marring the
surface. Each Gator Grommet™ has two
(2) thicknesses allowing for optimal fit on
various case shapes.
The Extender Arms (Fig. 1.5) will con-
nect directly to the corner Angle Brace.
Additional Extender Arms can be added
to provide additional support for the Gen-
Tent frame.
|
6 English
Gator
Grommet™
Kevlar
Strap
Angle Brace
Ratchet Handle
Ratchet
®
Adjustment
(top and bottom)
Prongs
with
Pivot
Pins
Extender
Release
Lever
Grommet Pins
(top and bottom)
Teeth
Center
Section
Installation Slot
(top and bottom)
Thin Side
Thick Side
4
3
2
1
Easy Removal
Slots
Arm
Fig. 1.1
Center
Slot
Fig. 1.2
Strap
Guides
Fig. 1.3
Fig. 1.4
Slotted
Receiver
Fig. 1.5