Publicidad
Idiomas disponibles
Idiomas disponibles
5. Breakdowns
While an electrical fault may be a nuisance, it is never dangerous. All motors and
controls are fitted with all necessary safety devices and have double insulation.
The table below gives possible solutions to malfunctions.
If you have any doubts contact your dealer.
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
The bed fails to respond
to the wireless remote
control
The bed fails to respond
to the wireless remote
control
The bed fails to respond
to the wireless remote
control
Nothing works
Cause
Caused by moving parts
touching each other.
The box spring is not
leveled because the floor
is not absolutely flat.
The reason for this may
be a missing part, or
parts that have not been
tightened properly or
have become loose when
the bed was moved.
The bed is not positioned
away from the wall.
There are unwanted
objects in the bed that
should not be there
(spoons, forks, pens,
etc.).
The child lock is on.
The batteries in the
remote control are
(almost) depleted.
The operating box is not
able to pick up the signal
of the handset. The
signal may fail to reach
the operating box if the
handset is at a
substantial distance.
Unidentified malfunction.
Search
Press one of the buttons
of the remote control.
The red light blinks.
Check if the operating
box has been fixed
properly.
Solution
Apply Teflon spray. Do
not use oil.
Make sure the floor is
absolutely leveled.
Tighten parts.
Position the bed away
from the wall.
Remove those objects.
Press the lock button on
the back side of the
remote control. Now the
green light blinks.
Replace batteries.
Place the operating box
in the designated spot.
Remove the plug from
the wall socket and wait
10 seconds before
replacing and/or remove
the batteries from the
remote control for one
minute.
EN
9
Publicidad
