Publicidad
Idiomas disponibles
Idiomas disponibles
Teach-in is complete when the door is open and the door
operator lights are on.
Check load switch-off according to Chapter 9,Safety
inspection.
16 Teaching in/deleting a remote
transmitter
Programming the remote transmitter:
During one of the 3 status messages A, B or C (see Chapter
10), press the pushbuttons
(approx. 1 s), F0 flashes in the display.
Select the desired function with the pushbuttons
Functions
F0 OPEN / Stop / CLOSE
F1 OPEN / Stop / OPEN
F2 CLOSE / Stop / CLOSE
F3 Stop
F4 Partial opening
F5 Light ON (restart light time)
F6 Light ON / OFF
F7 OPEN
F8 CLOSED
Press the desired key on the remote transmitter, the radio
command is taught in.
Note: The number of the function is shown in the display
during the transmission pulse.
Programming a new remote transmitter (TX) using an
existing one
Perform the following steps:
1
Go near door
2+3
programmed TX, within 3 seconds
4
new TX, within 10 seconds
5
wait 10 s
ATTENTION! Take note of the function that has been
assigned to each pushbutton using the figures in section M
(see page 237)
Magic 1000-3
and
simultaneously
and
.
IP2286 11/2021
Deleting (all) remote transmitter(s):
During one of the 3 status messages A, B or C (see Chapter
10), press the pushbuttons
seconds, FL flashes in the display. The status message
reappears after 3 seconds.
17 Operation
CAUTION: Mishandling the product can result in
injuries or material damage. Follow the basic safety
rules:
When opening or closing the door, do not block the interior or
exterior swivel ranges. Keep children away.
The door movements can be activated or stopped using the
remote transmitter provided or via switching elements such
as the wall keypad, which can be connected if desired.
Optional external features (such as the EMERGENCY
STOP) can also be connected to the door operator.
The operator must be connected to a
door before it is used. If it is not,
incorrect load values will be taught in
to the electronic system. This can cause
malfunctions.
18 Programming
Switch on programming mode
During one of the 3 status messages A, B or C (see Chapter
10) press the Menu pusbutton
seconds. The display changes to the menu (D).
Select programming menu
Select the desired menu with the pushbuttons
Show / change menu value
Displays: Press the Menu pushbutton
seconds, the menu value (E) is displayed.
Change: Change the value with the pushbuttons
Save: Press the Menu pushbutton
seconds, the programming menu (D) is displayed.
Exit programming mode
Press the Menu pushbutton
the display changes to the status message, changes are
saved.
If no key is pressed within 15 seconds during programming, it
automatically exits the programming mode.
and
simultaneously for >6
for longer than 1.5
and
.
for less than 1.5
and
.
for less than 1.5
for longer than 1.5 seconds,
17 / 240
DE
BG
FR
SE
DA
NO
FI
NL
IT
HU
RU
PL
SI
CZ
SK
GR
ES
PT
BG
HR
RO
UAE
Publicidad
