5. Insert a radio with attached battery or a stand-alone battery into an
available pocket.
Note: Grip the body of the radio when inserting or removing it from the
charger. Avoid pulling the radio antenna.
6. When the radio or stand-alone battery is properly seated in the
pocket, charging status is indicated by the associated Charge
Status LED. The associated Display provides additional
information. For single-display chargers, the display provides
charging status of only Pocket #1.
7. The battery is ready for use when the charging status is Steady
Green.
8. Turn on the radio only when the Charger Communications Module
is detached from a PC. Otherwise, turn OFF the device or radio.
Figure 2: Charging Battery Attached to Radio
Figure 3: Charging Stand-Alone Battery
15