Cameo S2 IP Manual De Usuario página 15

DISPLAY MAIN DISPLAY IN DMX MODE
The main display in DMX mode shows the currently set DMX start address, DMX mode and other
information (see illustration).
DMX start address
next free DMX start address
Press encoder =
Selection of the operating mode
DISPLAY MAIN DISPLAY IN THE ARTNET OR SACN OPERATING MODE
The main display in Artnet or sACN mode shows the DMX mode, the currently set DMX start
address, the IP address and universe group and the universe (see illustration).
DMX start address
Universe and group
Press encoder =
Selection of the operating mode
W-DMX
™
To pair a W-DMX receiver with a W-DMX compatible transmitter, W-DMX must be switched on in
the Settings menu of the receiver under Wireless Settings (WDMX State -> On), the unit must be
configured as a receiver (Operating Mode -> Receive) and the command Reset must be executed
(Receive Reset -> Yes). The receiver is now in pairing standby and waiting for a pairing request
from a transmitter. Start the pairing by selecting Link in the menu of the transmitter and confir-
ming; the pairing now takes place automatically. In the same way, several receivers can be paired
simultaneously or one after the other to a transmitter (e.g. for master/slave operation). A W-DMX
connection is always maintained until the connection is disconnected by means of the Reset com-
mand in the receiver or the Unlink command in the transmitter, regardless of whether a device
has been disconnected from the power supply in the meantime.
Currently activated operating mode
DMX mode
Currently activated operating mode
DMX mode
IP address
= DMX signal is present = no DMX signal
W-DMX status
Press encoder =
Open main menu (Menu)
W-DMX status
Press encoder =
Open main menu (Menu)
15