Cameo S2 IP Manual De Usuario página 27

SYSTEM INFORMATION (System Info)
Starting from the main display, press the right-hand rotary-push encoder to access the menu for
selecting the operating mode (Menu). Turn the left encoder (SELECT) to select System Info (note
the selection arrow on the left) and confirm by pressing the left encoder (ENTER).
This takes you to the submenu for calling up the system information (see table, selection by
turning the left encoder).
System Info
Main CPU
DRV CPU
LED Temp.
Op. Hours
Display
Signal Fail
Dim Curve
Dim Response
Red Shift
PWM
Calibr.
User calibration R=
User calibration G=
User calibration B=
User calibration W=
Auto Lock
Fan
WDMX
User Button 1
User Button 2
RDM UID
MAC Addr.
In order to be able to access all menu items in the fixture with the help of the Cameo
UNICON DMX/RDM controller via Fixture Menu, the menu items Stand Alone (with all
Stand Alone operating modes), EZ Remote and Slave are additionally located in the
main menu in addition to the Mode menu.
Vx.xx
Vx.xx
xx°F xx°C
xxxxx:xx h
Always On / Off after 20s
Hold / Blackout / User Colour 8 / Fade Out 10s
Linear / Exponential / Logarithmic / S-Curve
LED / Halogen
Off / Dim to Warm
650Hz / 1530Hz / 3600Hz / 12kHz / 18.9kHz / 25kHz
RAW / User / Factory / Smart
000–255
000–255
000–255
000–255
Off/On
Auto / Off / Constant Low / Constant Medium / Constant High
Off/On
EZ Remote / Mode Selection / HSI / Direct / Colour Coordinates
GEL / User Colour / Play Loop / Light Simulation
EZ Remote / Mode Selection / HSI / Direct / Colour Coordinates
GEL / User Colour / Play Loop / Light Simulation
xx xx xx xx xx xx
xxx.xxx.xxx.xxx.xxx
27