Preparing The Receiver; Setting The Voltage Selector; Connecting The Ac Power Cord (Mains Lead); Initializing The Receiver - Sony HT-M7 Manual De Instrucciones

Preparing the Receiver

Setting the voltage
selector
If your receiver has a voltage selector on the
rear panel, check that the voltage selector is set
to the local power supply voltage. If not, use a
screwdriver to set the selector to the correct
position before connecting the AC power cord
to a wall outlet.
Depending on the area, the VOLTAGE
SELECTOR may differ.
Connecting the AC power
cord (mains lead)
Connect the AC power cord (mains lead) to a
wall outlet.
AC power cord (mains lead)
To the wall outlet
30
US

Initializing the receiver

Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to revert back to the factory default
settings.
Be sure to use the button on the receiver to
perform this operation.
?/1
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
The "CLEARING" appears on the
display panel for a while, then changes to
"CLEARED".
Changes or adjustments made to the
settings are now reset to the defaults.