5: Preparing The Receiver And The Remote; Setting The Voltage Selector; Connecting The Ac Power Cord - Sony HT-DDW1500 Manual De Instrucciones

5: Preparing the receiver
and the remote

Setting the voltage selector

If your receiver and sub woofer has a voltage
selector on the rear panel, check that the
voltage selector is set to the local power supply
voltage. If not, use a screwdriver to set the
selector to the correct position before
connecting the AC power cord to a wall outlet.
Receiver
VOLTAGE
SELECTOR
120V
220V
240V
Sub woofer
VOLTAGE SELECTOR
220V
120V
30 GB
240V

Connecting the AC power cord

Connect the AC power cord to a wall outlet.
AC power cord
CENTER
+ –
SURROUND BACK
L
+ –
R
FRONT
S
Note
Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.
To the wall outlet