Publicidad
Idiomas disponibles
Idiomas disponibles
7. Start/stop switch
8. Fuel tank
9. Adjuster screws carburetor
10. Starter rope handle
11. Starter housing
12. Chain oil tank
13. Muffler
14. Chain brake and front hand guard
15. Front handle
16. Right hand guard
17. Clutch cover
18. Chain tensioning screw
19. Brake band
20. Oil pump adjustment screw
21. Chain catcher
22. Spiked bumper
23. Saw chain
24. Guide bar
25. Bar tip sprocket
26. Transport guard
27. Operator's manual
28. Combination wrench
29. Choke control
Symbols on the product
Careless or incorrect use of this product can
result in serious or fatal injury to the operator
or others.
Read the operator's manual carefully and
make sure you understand the instructions
before you use this product.
Always wear approved protective helmet,
approved hearing protection and protective
goggles or a visor.
Both of the operator's hands must be used
to operate the chainsaw.
Never operate the chainsaw holding it with
one hand only.
Never let the guide bar tip come in contact
with any object.
Warning! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
987 - 003 - 30.01.2019
towards the operator. May cause serious
personal injury.
Chain brake, activated (right). Chain brake,
not activated (left).
Choke lever in "open position".
Choke lever in "closed position".
Air purge.
Refuelling.
Chain oil fill.
XX
Computed kickback bar stopping angle
without actuated chainbrake, CKA wob.
XX
Computed kickback bar stopping angle with
actuated chainbrake, CKA wb.
yyyywwxxxxx
RedMax H30
Note: Other symbols/decals on the product refer to
certification requirements for certain markets.
Adjustment of the oil
pump.
The rating plate showing
serial number. yyyy is the
production year, ww is the
production week.
Recommended cutting
equipment in this exam-
ple: - Guide bar length: 16
inches - Max. nose radius:
10T - Saw chain type:
RedMax H30
3
Publicidad
