Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE DC RECEPTACLE
See Figure 12.
WARNING:
The 12 V DC receptacle is designed to charge vented wet
lead acid batteries only. Other types of batteries could
burst, causing personal injury and damage.
NOTICE:
The 12 V DC receptacle provides continuous charge. Do
not overcharge battery or leave battery unattended. Doing
so may cause damage to the battery.
NOTICE:
Do not use the generator to jump start vehicles. Doing
so could result in damage to the vehicle or it's electrical
components.
Place the auto idle switch in the OFF (O) position.
Using the battery clamps, connect a battery charging
cable assembly (not provided) to the battery terminal.
Connect the red wire to the positive (+) terminal first, then
connect the black wire to the negative (–) terminal. Make
sure all connections are secure.
NOTE: Be careful not to short across the terminals when
installing. Shorting the terminals together can cause
sparks, damage to the battery or generator, or even burns
or explosions.
NOTE: To prevent short circuit, keep away from a metal
surface during clamp connection.
Connect the battery charging cable assembly to the
12 V DC receptacle.
OPERATION
Start the generator.
NOTE: The AC receptacles can be used while the DC
receptacle is in use.
The battery will become slightly warm to the touch while
charging. This is normal and does not indicate a problem.
NOTE: Only use battery charging cable assembly to
charge vented wet lead acid batteries.
When batteries become fully charged, disconnect
the battery charging cable assembly from the battery.
Disconnect the negative (black) wire first, then the positive
(red) wire, being careful not to short across the terminals.
Always abide by the safety warnings provided with the
battery.
NOTE: Most batteries will be completely charged after
30 to 120 minutes. However, it is highly recommended
that you refer to your battery manufacturer's instructions
for specific charge times.
Unplug battery charging cable assembly and store for
later use.
HIGH ALTITUDE OPERATION
Your engine is configured for operation below 1500 feet
altitude at the factory. Your engine must be reconfigured for
operation above 1500 feet altitude. Operating the engine
with the wrong engine configuration at a given altitude may
increase its emissions, decrease fuel efficiency, degrade
performance, and cause irreversible damage. Engines
configured for high altitude operation cannot be operated
in standard altitude conditions. A qualified service center
should ensure that your engine is properly configured for
your location.
Page 15 — English
Publicidad
