Winding The Bobbin - Kenmore 385.19606 Manual De Instrucciones

•
Winding the bobbin
[] Draw the thread from the spool.
[] Guide the thread around the thread guide.
[] Thread through the hole in the bobbin from the
inside to the outside.
[] Put the bobbin on the bobbin winder spindle.
[] Push the bobbin to the right.
The LCD screen will indicate that the machine is in
the bobbin winding mode.
[] With the free end of the thread held in your hand,
depress the foot control. Stop the machine when it
has made a few turns, and cut the thread close to
the hole in the bobbin.
[] Depress the foot control again. When the bobbin is
fully wound, it will stop automatically. Return the
bobbin winder to its original position by moving the
spindle to the left, and cut the thread as shown.
• The machine will not sew until the spindle is in the
left position.
NOTE:
The position of the bobbin winder stopper is adjustable
depending on the required amount of thread on the
bobbin (example: 112 full or full). Using a screwdriver,
loosen the screw one turn or less, so that you can adjust
the position of the bobbin winder stopper. Do not take the
screw all the way out. Retighten the screw to fix the
stopper at the desired position.
34