Help Key; Manual Stitch Length; Variable Needle Position - Kenmore 385.19606 Manual De Instrucciones

Help key
[] Additional information o ralternative s ewing applications
forthefollowing stitches willbedisplayed w henpressing
thehelpkey.
Mode1 #1,#4,#6,#7,#9
Mode 2:#12,#13,#23
(Example: Pattern #1ofmode1)
[] Quilting
[] Zippersewing
Manual Stitch Length
Press "-" or "+" to adjust the stitch length.
To decrease length, press "-
To increase length, press -4-
The pre-programmed stitch length setting is suitable for
most of your sewing needs. However. you can change
these settings to accommodate different fabric
characteristics or achieve a desired effect. Hold down "-"
or "+" until you reach the desired setting.
* The reverse stitch length cannot be set longer than
1t8" (0.3 cm).
LENGTH
Variable Needle Position
These settings apply only to "straight" stitch patterns.
When you select straight stitch patterns, you can adjust
the left/right needle position. When you press "-", the
needle position will move to the left.
When you press "+", the needle position will move to the
right.
(_ Left (0.0)
(_ Middle (3.5)
(_ Right (7.0)
Note:
When using the straight stitch foot, make sure to use
center needle position (_.
Otherwise the needle may strike the sewing foot and
possibly break.
52
WIDTH
f-
+
©
@
®