Use; Battery Check/Setting On A New Machine - Advance Adfinity 17ST Instrucciones De Uso

USE

WARNING!
On some points of the machine there are some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.

BATTERY CHECK/SETTING ON A NEW MACHINE

WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly installed
or connected. The batteries must be installed by qualifi ed personnel only. Set the function electronic board and
the built-in battery charger according to the type of batteries used (WET or GEL/AGM).
Check the batteries for damage before installation.
Disconnect the battery connector and the battery charger plug.
Handle the batteries with great care.
Install the battery terminal protection caps supplied with the machine.
The machine requires two 12 V batteries, connected according to the diagram (57).
The machine can be supplied in one of the following modes:
Batteries (WET or GEL/AGM) already installed and ready to be used
1. Check that the batteries are connected to the machine with the connector (12).
2. (Only for Adfi nity™ X20R): Insert the ignition key (80) and turn it to "I".
(Only for Adfi nity™ 17ST - 20ST): Press the switch (71) or (73) to turn the machine on.
If the green warning led (81a) turns on, the batteries are ready to be used.
If the yellow or red warning led (816b) or (81c) turns on, the batteries must be charged (see the procedure in the Maintenance
chapter).
Without batteries
1. Buy appropriate batteries (see the Technical Data paragraph).
2. For battery choice and installation, apply to qualifi ed battery Retailers.
3. Set the machine and the battery charger according to the type of batteries (WET or GEL/AGM).
Adfi nity™ 17ST - 20ST - X20R
INSTRUCTION FOR USE
9096912000(4)2010-11
ENGLISH
11