Reset The System; Cleaning And Maintenance; Clean The Dust Collector And Water Tank - EUFY RoboVac L70 Hybrid Manual Del Propietário

English

Reset the System

You can reset the system if there is no response when pressing any button on RoboVac.
1. Make sure RoboVac is not on the Charging Base.
2. Use a clip to press the Reset button.
RoboVac will automatically turn off.
3. Dock RoboVac onto the Charging Base or press
The system is reset.
• After resetting the system, RoboVac may lose its map and the original settings
including the virtual boundary.

Cleaning and Maintenance

Before cleaning and maintaining, turn off the device and unplug the adapter.
For optimal performance, follow the instructions below to clean and maintain RoboVac
regularly. The cleaning/replacement frequency will depend on your usage habits of
RoboVac.
Recommended cleaning/replacement frequency
RoboVac Part Cleaning Frequency
Dust Collector After each use
Filter Once every week
Rolling Brush Once every week
Side Brush Once every month
Brush Guard Once every month
28
to turn it on.
Replacement Frequency
-
Every 6 months
Every 6-12 months
Every 3-6 months (or when visibly worn)
Every 3-6 months (or when the silicone
rubber strip on the brush guard becomes
visibly worn)
RoboVac Part Cleaning Frequency
Sensors Once every month -
Charging Pins Once every month -
Swivel Wheel Once every month -
Mopping Module After each use -
Mopping Cloth After each use Every 3-6 months (or when visibly worn)
Water Tank After each use -

Clean the Dust Collector and Water Tank

1. Open the top panel of RoboVac and press the release button to remove the dust collector
and water tank.
2. Take out the filter assembly.
3. Take out the pre-filter, foam filter, and high-performance filter.
4. Clean the filters with a vacuum cleaner or a cleaning brush. You can also wash the filters
for deep cleaning.
English
Replacement Frequency
29