Stihl RLA 240.0 Manual De Instrucciones página 31

7 Assembling the Lawn Scarifier
7 Assembling the Lawn
Scarifier
7.1 Attaching the Handlebar
► Switch the lawn scarifier off, pull out the acti‐
vation key and remove the battery.
► Place the lawn scarifier on a level surface.
► Push holder (8) onto bolts (7).
► Align upper handlebar (1) and centre handle‐
bar section (2) so that the bores align.
► Insert bolt (7) and align so that the bolt head is
flush with centre handlebar section (2) on both
sides.
► Place washer (4) on bolt (7).
► Screw on wing nut (3).
► Align lower handlebar (10) and centre handle‐
bar section (2) so that the bores align.
► Insert bolt (7) and align so that the bolt head is
flush with centre handlebar section (2) on both
sides.
► Place washer (4) on bolt (7).
► Screw on wing nut (3).
► Press cable (9) into holders (8).
The handlebar must not be dismantled again.
7.2 Removing the Combing Roller
from the Transport Compart‐
ment Before Use for the First
Time
► Switch the lawn scarifier off, pull out the acti‐
vation key and remove the battery.
► Place the lawn scarifier on a level surface.
► Open quick-clamping devices (1) and fold
down the handlebar to the rear.
0478-670-9809-B
► Hold the lawn scarifier at the lower transport
handle and upend.
► Remove the cable ties.
► Remove the combing roller from the transport
compartment and keep it in a safe place.
7.3 Assembling, Attaching and
Detaching the Grass Catcher
Box
7.3.1 Assembling the Grass Catcher Box
► Pull fabric (1) over frame (2) so that the base
plate is on the bottom and handle (3) is on the
outside of the fabric.
► Press plastic profiles (4) onto the frame.
The plastic profiles engage with a click.
7.3.2 Attaching the Grass Catcher Box
► Switch the lawn scarifier off.
► Open discharge flap (1) and hold it open.
► Take hold of grass catcher box (3) by han‐
dle (2) and suspend shaft (5) in mount (4).
► Set down discharge flap (1) on grass catcher
box (3).
7.3.3 Detaching the Grass Catcher Box
► Switch the lawn scarifier off.
English
31