Descargar Imprimir esta página

CASO DESIGN TC 2100 Thermo Control Manual Del Usuario página 40

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

• Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
• Do not set up the induction cooktop in the vicinity of appliance and objects which react
sensitively to magnetic fields (e.g.: Radios, televisions, cassette recorders, etc.).
• To operate correctly, the appliance requires a sufficient flow of air. Leave a 10 cm gap
on all sides when setting up the appliance.
• The cool air is drawn in by the underside of the appliance. Do not cover or block any of
the appliance's openings.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
13.5.2
Preventing Radio interference
The appliance can cause interference to radios, televisions or similar devices. Interference
can be removed or reduced using the following measures:
• Place the radio, television etc. as far away from the appliance as possible.
• Connect the appliance to a different socket, so that different electric circuits are being
used for the appliance and the receiver experiencing interference.
• Use a correctly installed aerial for the receiver in order to ensure good reception.
13.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device
If in doubt, ask your qualified electrician.
• The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been installed under the
oven or over hot or sharp surfaces.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
for damages that are caused by a missing or damaged protective conductor.
40

Publicidad

loading

Este manual también es adecuado para:

2223Tc 2100